*Air cooling scheme
*The EMI effect is good.
*The winding cost of the coil is low
*Minimize DC resistance
*The coil has a strong heat dissipation capacity
*The coil can be wound by equipment
*Minimize the DC resistance
*The height contrast is relatively lower
*Initial inductance:115uH~335uH
*DC BIAS：
Current：@20A~105A
Inductance：48uH~156uH
*The cost of magnetic core ferrite is relatively low
*Inductance：60uH
*Provide a path with high magnetic permeability to guide magnetic leakage
*Suppress eddy current loss and local heating to optimize EMI performance
*Initial inductance:200uH~380uH
Current：@50A
Inductance：60uH~140uH
*Can be produced automatically
*The cost of mold pressing is low
*Initial inductance:180uH~335uH
Current：@40A~85A
*Power density improvement
*Volume reduction
*Cost reduction
*Initial inductance:300uH
Current：@25A
Inductance：185uH
*Coils can be wound by equipment
*The anti-saturation ability is enhanced
*Initial inductance:170uH~335uH
Current：@20A~85A
Inductance：60uH~156uH
*The magnetic core has a strong heat dissipation capacity
*Ultimate high-frequency loss control
*EMI suppression design with relatively high space utilization
*Higher thermal conductivity
*Higher power density
*Higher reliability and longer lifespan
*Significantly reduce noise
*Comply with the requirements of the CLASS F insulation system
*Initial inductance:480uH
Current：@67A~81A
Inductance：180uH~270uH
